Some states require a franchisor to register, or file a disclosure, before offering a franchise to someone there. Franchise Sales holds outreach for prospects in those states until you confirm the state is cleared. It is on for every org with the +CRM/Franchise Sales add-on, and you can't turn it off. This is not legal advice. Check your filings with franchise counsel.
Which states
The built-in list is California, Hawaii, Illinois, Indiana, Maryland, Michigan, Minnesota, New York, North Dakota, Rhode Island, South Dakota, Virginia, Washington and Wisconsin.
A prospect is held when either of these is in one of those states:
- Their home state, worked out from the first three digits of the zip code they gave.
- The state in their territory interest, when it's written as "City, ST" (for example "Phoenix, AZ"), or as just the state code.
If SalesThumb can't work out a state from either field, the prospect isn't held by this rule. Enter a zip code or a "City, ST" territory on every prospect so the rule can work.
What gets held
On the prospect's page you'll see an amber banner: "Paused: [State] requires franchise registration. Mark the state registered or exempt in Compliance → State registrations." Under it, a link opens Open Compliance. While the banner shows:
- Sequence emails and texts are not sent. The enrollment pauses at the next email or text step with the reason State registration. Task and wait steps run as normal until then.
- AI outreach drafts are refused with the same message.
- Inbox replies, from your team or the AI, are switched off for that prospect.
- FDD, Franchise Agreement, Financial Disclosure and other binding document sends (letter of intent, deposit or option agreement, or a document marked as binding) are refused.
- Later steps of the deal, such as marking an offering document signed, converting the prospect and setting the franchise fee, are refused too. See the section on later steps below.
The only exception is recording an out-of-band FDD receipt, where the check can be overridden. See "Overriding the check" below.
Booking a meeting or a Discovery Day is not blocked. You see a warning instead that you can still meet, but shouldn't present or discuss the franchise offer until the state is cleared. You'll also see a warning if the prospect has no FDD receipt on file.
Don't email, text or pitch the franchise to the prospect by other means while they are held. The Power Dialer doesn't hold these prospects: calls are still allowed, so don't discuss or offer the franchise on a call until the state is Active or Exempt.
How to clear a state
Open FDD Compliance in the Franchise Sales sidebar (under Compliance & docs) and go to the State registrations tab. Click the pencil icon on the state's row, set its Status and click Save. Org owners and admins can do this by default.
The statuses are Not registered, Application pending, Active, Expired, Renewal pending and Exempt. Only two clear a state:
- Active, as long as the Expires date, if you entered one, hasn't passed.
- Exempt, if you've confirmed with counsel that you're exempt there.
Everything else holds the state, including a state with no row at all. Nothing is pre-filled. Enter only what you have confirmed. Once a state is cleared, the banner goes away. Paused sequence enrollments don't restart by themselves, so open the prospect and click Resume on each one.
A stricter check once you use the tracker
Once you've entered at least one row in State registrations, FDD, Franchise Agreement, Financial Disclosure and other binding document sends are checked for every state, not only the 14. A prospect whose state is not Active or Exempt is blocked, and a prospect with no state on file is blocked with a note to set Territory Interest to "City, ST".
Later steps are checked again
A registration can lapse after the documents go out, so the same check runs again later in the deal. While the prospect's state registration isn't cleared, these are refused:
- Marking an FDD, Franchise Agreement, Financial Disclosure or other binding document signed.
- Converting the prospect to a franchisee.
- Setting the franchise fee, and emailing the fee payment link.
The message names the step, for example "Can't convert this prospect.", and says what to update in Compliance → State registrations. If your org has no rows in State registrations yet, an override reason you already gave for this prospect, for example on an out-of-band FDD receipt, carries forward to these steps. The prospect can't pay the fee through the payment link either. They're told to contact their franchise rep, and no payment is taken.
A signature that DocuSign reports as already done is still recorded, because it has already happened. It gets a note on the prospect's timeline and in your audit trail that the registration wasn't cleared.
Overriding the check
Only the owner, or a member the owner gives the Override Franchise Sales compliance gates permission, can override the state registration check. The owner grants it under HQ → Users.
An override needs a reason category and a written reason of at least 30 characters. The categories are:
- Registration is effective but not yet recorded here
- An exemption applies to this sale
- Franchise counsel approved this in writing
- Other (explain in the reason)
Both the category and the reason are kept in your audit log. If the audit record can't be saved, the override doesn't happen.
Fee deferral and escrow states
Some states make you defer the franchise fee or hold it in escrow as a condition of registration. Turn on Fee must be deferred or held in escrow on that state's row in State registrations. For a prospect in that state, the fee can't be set, sent or paid until an org owner or admin records on the Franchise fee card that the condition is met, using Record condition met and a short note on how it was met. If you later raise the fee above the amount the condition was recorded for, the new fee is refused. You can then record the condition again only for the exact fee amount that was just refused.
Frequently asked questions
Q: Does SalesThumb know which states require registration?
A: It holds outreach for the 14 states listed above. It does not know your own filing dates or exemptions. Enter those yourself in State registrations, as confirmed with franchise counsel.
Q: A prospect is in Texas but still shows the Paused banner. Why?
A: The rule looks at both their home state from the zip code and the state in their territory interest. If either is one of the 14 states and isn't cleared, they are held.
Q: I marked the state Active but the sequence is still paused. What now?
A: Sequences don't restart on their own. Open the prospect's page and click Resume on the paused enrollment. Only org owners and admins can.
Q: Can I still call a held prospect?
A: The Power Dialer isn't switched off by this rule, but the same caution applies. Don't discuss the franchise offer until the state is cleared.
Q: Why can't I send an FDD to a prospect when I've already marked their state Active?
A: Check the Expires date. An Active registration with a date in the past no longer counts as cleared. Update the date or the status.
Q: Who can override the state registration check?
A: Only the owner, or a member the owner gives the Override Franchise Sales compliance gates permission under HQ → Users. Each override needs a reason category and a written reason of at least 30 characters, and both are kept in your audit log.